Warbird Information Exchange

Packard Rolls-Royce Merlin tool roll
Page 2 of 2

Author:  mercman [ Tue Mar 11, 2014 5:48 pm ]
Post subject:  Re: Packard Rolls-Royce Merlin tool roll

Hi new to this site I have just purchased a tool kit that sounds the same as bru-d . its been in someone's garage for the last 30 years .its a bit rusty but looks like its hardly been used and nearly complete, apart from one important bit which is the white tool flap section at the top can anyone send me a decent photo of this . I think my kit sounds more like the At9211 . if anybody wants any photos of their missing pieces I can glady send them thanks

Author:  Andylad [ Wed Oct 28, 2015 3:14 pm ]
Post subject:  Re: Packard Rolls-Royce Merlin tool roll

O.K. i know this is an old thread but just thought i would add a little. The 3.5" adjustable spanner AT-80** is possibly a Diamalloy wrench. I have seen a 4" wrench marked AT-8055 that could be the one. These were made by the Diamond Calk Horseshoe Co. in the 1940s. The missing ratchet AT-8022 that you thought may be made by Bonney is in fact made by Snap On. I know this as i have one with a date letter from 1945 and apart from the finish it is identical to a 3/8" Snap On Ferret ratchet i have from 1941. Hope this is useful to someone, cheers.

Page 2 of 2 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group