| Warbird Information Exchange http://warbirdinformationexchange.org/phpBB3/ |
|
| T-6 Main Strut Rebuild http://warbirdinformationexchange.org/phpBB3/viewtopic.php?f=26&t=56525 |
Page 1 of 1 |
| Author: | Ken [ Sun Aug 23, 2015 6:58 am ] |
| Post subject: | T-6 Main Strut Rebuild |
I don't have access to any manuals here - is there a procedure in any of the T-6 pubs detailing the rebuild of a main gear strut? Any nice-to-know tips not covered in the book? thanks, Ken |
|
| Author: | b29flteng [ Sun Aug 23, 2015 8:50 am ] |
| Post subject: | Re: T-6 Main Strut Rebuild |
It's a straight forward repack. If you have access to Parker O-Lube use it mixed with some hydraulic fluid to coat everything. Be careful not to fold the edge of the chevron seals when installing them. Polish any nicks on the chrome strut before reassembling. |
|
| Author: | Cvairwerks [ Sun Aug 23, 2015 12:43 pm ] |
| Post subject: | Re: T-6 Main Strut Rebuild |
Make doubly sure you depressurize it before trying to disassemble it. Same thing with split wheels. There have been numerous people hurt or killed because they didn't take the few seconds to make sure all the pressure had been released first. I've had to remind a few folks at work, that a number of our systems are still pressurized even with the jet shut down. |
|
| Author: | Matt Gunsch [ Mon Aug 24, 2015 8:25 am ] |
| Post subject: | Re: T-6 Main Strut Rebuild |
The easiest way to do the struts is to remove the lower leg and put the seals onto the chrome cylinder and slide into place. I use a expanding automotive piston ring compressor over the seals to get them past the threads on the upper strut housing, and a couple of pieces of large PVC pipe to push the seals into place. One piece is a PVC coupling with the ring in the center removed, it should be as close to the strut diameter as possible, the other is a adaptor that is the same size as the strut on one side, and as large as possible on the other to act as a pusher. something like this for the compressor, you want as long a reach as possible into the strut http://guide.alibaba.com/shop/4-in-piston-ring-compressor-by-usatnm_36207002.html something like this for the pusher http://www.lowes.com/pd_23318-1814-PVC+00102++1000___?productId=3132737&pl=1&Ntt=pvc+pipe+couplings |
|
| Author: | Ken [ Wed Aug 26, 2015 6:29 am ] |
| Post subject: | Re: T-6 Main Strut Rebuild |
Mods, my apologies, if you'd please move this to the T-6/SNJ thread. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|