Joined: Mon Jun 14, 2004 8:41 pm Posts: 1430 Location: North Texas
|
You will probably need to go up one or two assembly levels to determine if it is constant. Not having the drawings available to look at, I'm working blind, but off of typical industry practices of the times. Move up the assembly drawings to the rib installaton and you may need to check at every location to be sure you don't miss a reference to it. You shouldn't have to go any higher than the skin installation drawings to figure it out. Another place to check is if the drawing set you are working off has the tooling drawings included. I seem to remember that someone had those in the set of drawings they had.
|
|