Warbird Information Exchange

DISCLAIMER: The views expressed on this site are the responsibility of the poster and do not reflect the views of the management.
It is currently Thu Mar 28, 2024 8:15 am

All times are UTC - 5 hours


Classic Wings Magazine WWII Naval Aviation Research Pacific Luftwaffe Resource Center
When Hollywood Ruled The Skies - Volumes 1 through 4 by Bruce Oriss


Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: Generator operation
PostPosted: Sat Oct 12, 2013 2:58 pm 
Offline
Maker of Spiffy models
User avatar

Joined: Fri Apr 30, 2004 6:50 pm
Posts: 1883
Location: Montréal
Hi guys,

I had a discussion with someone about the operating procedure for a generator, and he said that to prevent damage to the generator control unit, it should be switched off during the approach, in base or on final.

I never heard of such a technique before, but apparently it was common "back in the day".

What do you think?

:?

_________________
Olivier Lacombe -- Harvard Mk.4 C-GBQB


Top
 Profile  
 
 Post subject: Re: Generator operation
PostPosted: Sat Oct 12, 2013 6:19 pm 
Offline
3000+ Post Club
3000+ Post Club
User avatar

Joined: Tue Jul 17, 2007 9:11 pm
Posts: 3160
Location: MQS- Coatesville, PA
Ollie wrote:
Hi guys,

I had a discussion with someone about the operating procedure for a generator, and he said that to prevent damage to the generator control unit, it should be switched off during the approach, in base or on final.

I never heard of such a technique before, but apparently it was common "back in the day".

What do you think?

:?

Doesn't seem to be a large failure rate that I have experienced or heard of with them and we leave them on.
Radios and such back then drew a bigger load so that it could suck power and overload the generator at low RPM. Particularly if you were doing pattern work shortly after startup so the battery would still be drawing high amps to recharge after the start.
Back in the day the batteries were also rated lower in capacity IIRC.
I would guess apples and oranges in operation.

_________________
Rich Palmer

Remember an Injured Youth
benstear.org
#64- Stay Strong and Keep the Faith

BOOM BOOM, ROUND ROUND, PROPELLER GO

Don't Be A Dilbert!


Top
 Profile  
 
 Post subject: Re: Generator operation
PostPosted: Sat Oct 12, 2013 11:48 pm 
Offline
Been here a long time
Been here a long time

Joined: Sun May 02, 2004 1:16 am
Posts: 11276
Generator output is based only on RPM. Is RPM that low on approach or base? The generator should come on line at about 1400 RPM as I recall.

If the reverse current relay is operating, that should prevent the battery from feeding the generator below the coming-in speed, right? I just don't understand how the generator can be harmed if everything is working properly.

If that statement is true, the generator should always be switched off when it isn't charging like during taxi.


Top
 Profile  
 
 Post subject: Re: Generator operation
PostPosted: Sun Oct 13, 2013 7:28 am 
Offline
Maker of Spiffy models
User avatar

Joined: Fri Apr 30, 2004 6:50 pm
Posts: 1883
Location: Montréal
Thanks guys.

Brandon, that's how I understood the operation of a generator. In final, RPM can be below 1 400, and it will stay below that limit until shut down, but as you said, if the reverse current relay is serviceable, no harm should be done.

This all started when our Beaver came back from flying with a smoke-filled cockpit, the GCU had just left for a better world.

I'm not a fan of switching stuff on final mind you.

_________________
Olivier Lacombe -- Harvard Mk.4 C-GBQB


Top
 Profile  
 
 Post subject: Re: Generator operation
PostPosted: Sun Oct 13, 2013 4:41 pm 
Offline
Been here a long time
Been here a long time

Joined: Sun May 02, 2004 1:16 am
Posts: 11276
In my experience, stuff usually fails when you are messing with it! Unless the operating handbook says differently, I'd leave it alone. I don't think that kind of failure is too common, but I could be wrong.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group