Glare shield edge padding

Smaehr · **Joined:** Sun Oct 27, 2013 5:53 pm **Posts:** 30

Anyone have a source for replacement of the round padding that runs along the front edge of the instrument panel glare shield. Mine has disintegrated. Lance has had it in the past but does not have any left.

Steve Maehr
SNJ5 - N3261G

Mustanger55 · **Posted:** Tue Nov 11, 2014 6:45 pm

Pioneer Aero Services???? http://www.pioneeraerosvc.com/

Mostly Mustang stuff but likely has same or similar extrusions.

Norm
aka Mustanger

Smaehr · **Joined:** Sun Oct 27, 2013 5:53 pm **Posts:** 30

Thanks Norm. I will check them out.

rcaf_100 · **Posted:** Fri Nov 14, 2014 12:56 am

Lance doesn't have any? :shock:

I just ordered a pair for our Harvard Mk 4 restoration at the end of September...part #88-31826-4 or 3P2-1-48

:partyman:

Smaehr · **Joined:** Sun Oct 27, 2013 5:53 pm **Posts:** 30

Checked with them a few months back. I will try them again.

Thanks

Smaehr · **Joined:** Sun Oct 27, 2013 5:53 pm **Posts:** 30

Lance does in fact have it in stock now.
Thanks.

Smaehr · **Joined:** Sun Oct 27, 2013 5:53 pm **Posts:** 30

Got the padding from Lance. Anyone have a good technique for attaching it. It appears that several sets of holes have been drilled so I am guessing that the rubber pad was put on and then drilled for the attaching screws. I would prefer not drilling a third set of holes.

Warbird Information Exchange

Glare shield edge padding

Who is online