Warbird Information Exchange

DISCLAIMER: The views expressed on this site are the responsibility of the poster and do not reflect the views of the management.
It is currently Thu Mar 28, 2024 9:05 pm

All times are UTC - 5 hours


Classic Wings Magazine WWII Naval Aviation Research Pacific Luftwaffe Resource Center
When Hollywood Ruled The Skies - Volumes 1 through 4 by Bruce Oriss


Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Wed Jun 08, 2016 3:41 pm 
Offline
1000+ Posts!
1000+ Posts!
User avatar

Joined: Sun Jul 11, 2004 4:55 pm
Posts: 1105
Location: Australia
Hello folks,

I am trying to explore possible variations in the design and production of T6 / SNJ / Harvard engine cowlings and in particular the internal radius from the outside face of the prop shaft to the inside edge of the cowl nose.

Could I ask those of you with an NAA aircraft in the hangar to take two simple measurements for me and post them, and the aircrafts ID and model in this thread?

I am after two measurements (1 each side of the prop shaft to allow for a cowl that is sitting offset), and to measure in inches down to 1/8" or better the distance from the face of the prop shaft to the inside radius lip of the cowl nose, ideally horizontally from the prop and in both directions.

ie I am trying to measure the size of the "hole" smiles

The two measurements, allowing for a standard diameter of the prop shaft, will then give me the diameter of the internal opening of the cowl, and I am keen to see if this is standardised across the NAA family or if it varies from factory or model?

I am expecting it to be uniform between the T6 and SNJ but I am not so sure about a Canadian Harvard etc

Any assistance would be greatly appreciated.

Regards

Mark Pilkington

_________________
20th Century - The Age of Manned Flight
"from Wrights to Armstrong in 66 years -WOW!"


Top
 Profile  
 
PostPosted: Wed Jun 08, 2016 9:51 pm 
Offline
Been here a long time
Been here a long time

Joined: Sun May 02, 2004 1:16 am
Posts: 11276
See my answer here:

viewtopic.php?f=3&t=58080


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group