Warbird Information Exchange
https://warbirdinformationexchange.org/phpBB3/

Air Brushes
https://warbirdinformationexchange.org/phpBB3/viewtopic.php?f=15&t=3713		 Page 1 of 1
Author:  TimAPNY [ Tue May 17, 2005 3:31 pm ]
Post subject:  Air Brushes
So what do you all use, I need an upgrade the junky thing I use and want on that is going to let me bring my modeling to the next level. Without breaking the bank.
Author:  Ollie [ Tue May 17, 2005 8:40 pm ]
Post subject: 
Iwata Eclipse HP-BCS.

It works wonder!

8)
Author:  TimAPNY [ Wed May 18, 2005 11:12 am ]
Post subject: 
I may wait a few months before trying to buy that, I may get locked out of the house. :shock:

But it does look pretty nice.
Author:  Ollie [ Wed May 18, 2005 1:11 pm ]
Post subject: 
Mine cost me about 125$ or maybe less, it was real cheap.

I got it from Curry's in Toronto, they give stellar service and have very good prices.

8) :wink: :D
Author:  Don Martin [ Fri May 20, 2005 9:35 pm ]
Post subject: 
Hi Tim,
For all the diehards out there, I still use my old Badger 200 single action. Gets the job done-looks good at 5ft or better(also known as the 5ft Rule :wink: )
Don
Author:  Nathan [ Fri Jun 24, 2005 7:34 pm ]
Post subject:  Re: Air Brushes
Hi Tim,

Nice to see you. I just signed on for this site. See ya at HAG.

-Nathan
Author:  TimAPNY [ Mon Oct 10, 2005 3:29 pm ]
Post subject: 
I’m thinking of going with the Iwata Eclipse HP-BC airbrush. I’ve used airbrushes before, I’m not total ignorant of them but far from experienced in there use.

Can I use my 5-gallon air compressor with an airbrush? I use it with my brad-nail gun and stapler so I figure that I should be ok with an airbrush. Any special adapters I will need?

What else should I be putting on my list of things I will need to get started (I have the airplane kits covered)?

Anybody recommend a spot to buy my gear from? I want an airbrush not a cyber-screwing.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/