Warbird Information Exchange

DISCLAIMER: The views expressed on this site are the responsibility of the poster and do not reflect the views of the management.
It is currently Mon Jun 16, 2025 11:46 pm

View unanswered posts | View active topics


Board index » General Discussion » The WIX Hangar

All times are UTC - 5 hours


Classic Wings Magazine WWII Naval Aviation Research Pacific Luftwaffe Resource Center
When Hollywood Ruled The Skies - Volumes 1 through 4 by Bruce Oriss


Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Previous topic | Next topic 
Author Message
bdk
PostPosted: Sun Jan 10, 2010 7:34 pm 
Offline
Been here a long time
Been here a long time

Joined: Sun May 02, 2004 1:16 am
Posts: 11324
Anyone have the minimum blade chord and thickness dimensions for a T-6 prop (6101A-XX)? The stations are measured from the prop centerline, not the blade butt, right?

I have an extra 12D40 hub with some unknown blades. The blades just don't seem to match up with the data I have for T-6 blades... Either the data I have is wrong or the blades are Ag blades?????

Thanks!
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » General Discussion » The WIX Hangar

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 285 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Switch to mobile style
Powered by phpBB® Forum Software © phpBB Group