Page 1 of 1

P-51 induction trunking and other bits

Posted: Fri Mar 30, 2007 5:23 pm
by Phil Earthey
We're after induction trunking for a Mustang, the ducting that runs under the engine. Also after a few other parts, as follows:

Oil Cooler
Elevator and Rudder balance weights
Elevator trim tabs
Rudder and Elevator trim jacks
Engine mount and parts

Any ideas most welcome.

Thanks,

Phil

Posted: Fri Mar 30, 2007 8:35 pm
by visaliaaviation
As we have all the microfilm and CD's of all NAA Mustang parts and assemblies, we could make them for you.

Early P-51B's had plywood trim tabs on rudder and elevators. Later were
phenolic and possibly metal.

Charlie at visaliaaviation@sbcglobal.net or dawnpatrolaviation.com

P-51 parts

Posted: Sat Mar 31, 2007 3:11 pm
by Phil Earthey
Thanks Charles,

We have a full set of manuals and drawings on both microfiche and paper (the drawings alone come to some 60 A4 binders). We have a parts manufacturing facility in house and are knocking bits out as we need them. There are, however, just some parts I'bd prefer not to have to produce from new.

BW,

Phil