Page 1 of 1

Need help identifying this part

Posted: Wed Mar 24, 2021 8:52 pm
by DesertExplorer
I found this part near Mojave, Ca recently. Approximately 2"X2"X1". CVS-43131-1 is stamped on one side and appears to be made of lead. There are scuff marks about 1/3 of the way up the slope that make it look like it was wedged under something. Any ideas?

Re: Need help identifying this part

Posted: Thu Mar 25, 2021 3:11 pm
by bdk
Probably a control surface mass balance weight.

Re: Need help identifying this part

Posted: Fri Mar 26, 2021 6:13 pm
by DesertExplorer
Thank you bdk. That gives me an area to start digging into.