Joined: Fri Apr 30, 2004 11:44 am Posts: 3293 Location: Las Vegas, NV
|
This is also on the TORA website, concerning the modifications made to the BT-13 to make a Val replica:
Two dummy gun ports consisting of 1½-inch tube installed on top section of ring cowl.
Eighteen stainless steel 9-inch by 9-inch cowl flaps added to ring cowl.
Carburetor air scoop relocated from side of accessory section to bottom of accessory section.
Common air scoop for oil cooler and carburetor installed on bottom of accessory section.
Dummy exhaust stack added on left-hand side of accessory section.
Both side cowlings on accessory section modified to vent accessory section air overboard.
Engine mount bolts replaced with NAS149 OH-28 bolts.
Raise cowling forward of canopy 1½ inches.
Installed dummy bombsight forward of windshield.
Installed 26-inch extension plus in fuselage aft of the rear canopy.
Rear canopy rail raised 7¼ inches and rear canopy cut down to match.
Rear canopy modified to fold up.
Two-foot-3-inch antenna mast mounted on top of rear canopy.
All cables to tail surface controls extended 26 inches.
Each wing tip extended 24 inches.
Installed fiberglass pants on main gear.
Installed fiberglass dorsal fin 30 inches long.
Installed dummy dive brakes under both wings.
Rear cockpit seat reversed.
Gun rest added to rear cockpit.
Changed fuselage contour aft of canopy – raised 2½ inches at top and narrowed 3 inches at bottom.
Replaced R-985 engine with R-1340 AN-1 engine s/n ZP105915 – supplied by 20th Century Fox.
Propeller replaced with 12D40 Hamilton Standard supplied by 20th Century Fox.
|
|