Need a bit of T-6 Stringer Extrusion

DISCLAIMER: The views expressed on this site are the responsibility of the poster and do not reflect the views of the management.

This is the place where the majority of the warbird (aircraft that have survived military service) discussions will take place. Specialized forums may be added in the new future
Post a reply
chippie51
  • chippie51
  • Posts: 192
  • Joined: Fri May 18, 2007 6:28 pm

Need a bit of T-6 Stringer Extrusion

Thu Jun 20, 2013 5:02 pm

Hi, we need a few feet of K14280 / C180T extrusion for our T-6. Just six foot or so.

Also need a top L beam that runs across the top of the rear fuselage frame 55-41169-2.

I know these may be available from Lance, however I'd rather support the WIX community economy.

Thanks
Post a reply
Switch to full style

Powered by phpBB © phpBB Group.

phpBB Mobile / SEO by Artodia.

Board index